Please select a wishlist

Cego Surelock Latch 3 Hooks 2 Rollers Split Spindle Multipoint Door Lock - Shootbolt Compatible

Cego Surelock Latch 3 Hooks 2 Rollers Split Spindle Multipoint Door Lock - Shootbolt Compatible
Notify me when this product is in stock
or call us on 020 8662 4010


Alternative products available

3504009 See Alternative

This part is discontinued and is no longer available.

However, part: 66350085AA is a potential alternative. This replacement is almost a perfect match. Some adjustment may be required depending on how the door has been prepared.

A newer Cego Surelock which is a rebranded Era lock. Plastic snib under the latch will be stamped Surelock.

Operation: Split Spindle

To lock the door

1. Lift the handle upwards to engage the locking points.

2. Lock the locking points and main deadbolt (if present) by turning the key.

To unlock the door

1. Unlock the system by turning the key.

2. Push the handle downwards to disengage the locking points and retract the latch.

Latch Reversal: Undo screwsin the latch, remove, reverse, reinsert and replace screws.

You may find this lock used as an UPVC door lock or an aluminium door lock.

How can I tell who the manufacturer is of my multipoint lock?

Check down the faceplate and look for a brand name or logo to identify the manufacturer.


How do I find out the operation of my multipoint door lock?

  • 1. If you only use the key to unlock all of the locking points then the operation is called Key Wind.
  • 2. If you lift the handle and turn the key to lock then the operation is called Lift Lever.
  • 3. If from the outside you unlock with the key, pull handle down to disengage the locking points and turn the key to open the door then this operation is called Nightlatch or Split Spindle.
  • 4. If lifting the handle fully locks the door without the use of a key then this operation is called Auto Locking.


How do I measure my multipoint door lock?

Always measure in millimetres.

  • 1. Backset – Measure the distance from the edge of the faceplate back to where the key goes into the door cylinder.
  • 2. Centres – Measure the distance from centre of handle spindle down to where the key goes into the door cylinder.
  • 3. Locking points – Measure the distance from centre of the locking point to the centre of handle spindle then repeat for other locking points.
  • 4. Faceplate – Measure the distance across the width of the face and full length of the faceplate.
  • 5. Gearbox – Measure the height and depth of the gearbox.


How do I know if my multipoint door lock is left or right handed?

99% of multipoint door locks are field reversible, instructions for which are under product information. For those models which are handed please refer to the handing chart to determine which hand you require.


Do you stock a gearbox only for this lock?

Yes our part number is ERACASE35THIN.

All product options

All product options
Product Code Backset Faceplate Operation StockRRPDiscountPriceQuantity
3504009
35mm
Flat 16mm - Square Ends
Split Spindle
---
--,--
--