Ucem Latch Deadbolt 6 Pin Bolts Key Wind Operated Multipoint Door Lock
This part is discontinued and is no longer available.
However, part: UM3D5085 is a potential alternative. This replacement is almost a perfect match. Some adjustment may be required depending on how the door has been prepared.
A heavy duty European made lock featuring key wind operation and U-rail faceplate with a distinctive 85mm centres and 50mm backset configuration.
Operation: Key Wind
To lock the door
1. On closing the door, the latch is automatically engaged.
2. Turn the key to throw and engage or "wind" out the locking points.
To unlock the door
1. Turn the key to unlock the door by "unwinding" the locking points.
2. A further quarter turn of the key will retract the latch.
Insert a screwdriver into back of case, push the latch clear of faceplate, twist to reverse and release.
Once you have reversed the latch you may find the latch sticks, if this happens then release the tension on the screw above the latch slightly which will rectify the problem
You may find this lock used as an UPVC door lock, an aluminium door lock, a timber multipoint door lock or a composite door lock .
- Manufacturer: Ucem
- Backset: Select from drop-down - How do I measure the backset?
- Centres PZ: 85mm - How do I measure the centres?
- Faceplate: Select from drop-down - How do I measure the faceplate?
- Spindle Size: 8mm
- Pin Bolts: 6
- Deadbolts: 1
- Latch: 1
- Main Gearbox: Latch & deadbolt
- Operation: Select from drop-down - What is the operation?
- Spindle: Single 8mm
- Handing: Non handed
- Distance Between Inner Locking: 1490mm
- Height: 2225mm
- Top Pin to Spindle: 710mm
- Bottom Pin to Spindle: 780mm
How can I tell who the manufacturer is of my multipoint lock?
Check down the faceplate and look for a brand name or logo to identify the manufacturer.
How do I find out the operation of my multipoint door lock?
- 1. If you only use the key to unlock all of the locking points then the operation is called Key Wind.
- 2. If you lift the handle and turn the key to lock then the operation is called Lift Lever.
- 3. If from the outside you unlock with the key, pull handle down to disengage the locking points and turn the key to open the door then this operation is called Nightlatch or Split Spindle.
- 4. If lifting the handle fully locks the door without the use of a key then this operation is called Auto Locking.
How do I measure my multipoint door lock?
Always measure in millimetres.
- 1. Backset – Measure the distance from the edge of the faceplate back to where the key goes into the door cylinder.
- 2. Centres – Measure the distance from centre of handle spindle down to where the key goes into the door cylinder.
- 3. Locking points – Measure the distance from centre of the locking point to the centre of handle spindle then repeat for other locking points.
- 4. Faceplate – Measure the distance across the width of the face and full length of the faceplate.
- 5. Gearbox – Measure the height and depth of the gearbox.
How do I know if my multipoint door lock is left or right handed?
99% of multipoint door locks are field reversible, instructions for which are under product information. For those models which are handed please refer to the handing chart to determine which hand you require.
Do you have a gearbox for this multipoint lock?
No a gearbox is not available for this model.