Please select a wishlist

GU Ferco Latch 2 Rollers Multipoint Door Lock

GU Ferco Latch 2 Rollers Multipoint Door Lock
Rating
0%
(0)
Notify me when this product is in stock
or call us on 020 8662 4010
Order code: G1577718
RRP Please log in to view prices
Log in to view prices and stock availability

GU Ferco Latch and 2 Roller lock with extensions for shootbolts.

This lock has been discontinued by Ferco and the A0279222 is a suitable replacement - The rollers are in slightly different place and shootbolts cannot be used.

Backset: 35mm

Centres: 92mm

Operation: Lift lever.

Latch reversal: Depending on date of manufacture either:Push the latch in to reveal a screw in side of case. Undo screw to remove the latch, reverse, reinsert and replace screw or Insert small flat bladed screwdriver in the small slot on side of case marked R/L. Push upwards to release latch, reverse and reinsert.

  • Case height: 198mm
  • Case depth: Backset + 16mm
  • Overall length: 1530mm
  • Distance between rollers: 700mm

There are no documents for this product

How can I tell who the manufacturer is of my multipoint lock?

Check down the faceplate and look for a brand name or logo to identify the manufacturer.


How do I find out the operation of my multipoint door lock?

  • 1. If you only use the key to unlock all of the locking points then the operation is called Key Wind.
  • 2. If you lift the handle and turn the key to lock then the operation is called Lift Lever.
  • 3. If from the outside you unlock with the key, pull handle down to disengage the locking points and turn the key to open the door then this operation is called Nightlatch or Split Spindle.
  • 4. If lifting the handle fully locks the door without the use of a key then this operation is called Auto Locking.


How do I measure my multipoint door lock?

Always measure in millimetres.

  • 1. Backset – Measure the distance from the edge of the faceplate back to where the key goes into the door cylinder.
  • 2. Centres – Measure the distance from centre of handle spindle down to where the key goes into the door cylinder.
  • 3. Locking points – Measure the distance from centre of the locking point to the centre of handle spindle then repeat for other locking points.
  • 4. Faceplate – Measure the distance across the width of the face and full length of the faceplate.
  • 5. Gearbox – Measure the height and depth of the gearbox.


How do I know if my multipoint door lock is left or right handed?

99% of multipoint door locks are field reversible, instructions for which are under product information. For those models which are handed please refer to the handing chart to determine which hand you require.


Do you have a gearbox for this multipoint lock?

Yes our part numbers are GUCASE28, GUCASE, GUCASE40 and GUCASE45.